Lights that suddenly appear much brighter than normal — or that alternate between very bright and very dim — are a warning sign that something is wrong with your electrical system. This isn’t a bulb problem. Here’s what causes it and why it needs prompt attention.
The most common and most dangerous cause of sudden overbright lights is a broken or loose neutral conductor — either at the utility’s connection point or at the main service entrance. In a normal 120V circuit, the hot wire delivers power and the neutral returns it at zero volts. If the neutral is interrupted, the two legs of your 240V service begin sharing a single neutral path in an unbalanced way. Loads on one leg see higher than 120V; loads on the other leg see lower. The result: some lights burn extremely bright while others dim, and high-voltage-sensitive equipment can be damaged or destroyed.
A lost neutral is an emergency. Turn off large appliances and sensitive electronics immediately — refrigerators, televisions, computers, and any device with a power supply can be damaged within minutes at overvoltage. Call your utility (Toronto Hydro or Hydro One) and report that your lights are overbright and cycling — they will dispatch a crew to check the service connection. Do not delay. A lost neutral can damage thousands of dollars of appliances in a short time.
A less urgent but still abnormal cause is a utility voltage problem — the supply voltage from the transformer is higher than the standard 120V. Ontario utilities are required to maintain voltage within 5% of nominal. If your lights are consistently bright (not cycling) and you have a multimeter, check the voltage at an outlet. Readings above 127V indicate an overvoltage condition at the transformer — report it to your utility. A wrong-wattage bulb in a dimmer circuit can also cause brightness inconsistency, but this affects only that fixture, not the whole house.
Lost-neutral events often happen after a utility crew has worked on lines in the area, or after a severe windstorm. The neutral conductor at the weatherhead (where the service wires attach to your home) can become corroded or physically damaged over decades. We recommend including a weatherhead and service entrance inspection in any home electrical assessment — it’s not visible in the panel, and a corroded neutral is a ticking clock. The repair is typically done by the utility to the meter socket and by an ESA-licensed electrician from the meter socket into the panel.
Lights behaving abnormally or suspect a lost neutral? Call us at 416-838-9006 or visit our contact page — we respond to emergency electrical situations across the GTA.
Electrician Since 2008 Journeyman Electrician Designated Master Electrician at EZSMART Corp