Lockout/tagout (LOTO) is a safety procedure used in industrial and commercial settings to prevent accidental energization of electrical equipment during maintenance. For homeowners, the concept translates into a straightforward practice: physically securing your electrical panel so a circuit cannot be switched back on while someone is working. Here’s how to do it correctly.
Turning off a breaker is not enough if someone else in the household could flip it back on. This risk is real in occupied homes — a family member switches the kitchen breaker back on not knowing a contractor is working in the panel, or a child restores a breaker they think tripped by accident. A simple lockout device prevents this without requiring everyone in the house to know the work is in progress.
Standard residential panels don’t accept industrial LOTO padlocks directly, but breaker lockout attachments are available at any hardware store for under $10. These snap onto the breaker and prevent it from being toggled. For the main breaker, main breaker lockout covers are available that physically block the entire main disconnect. For maximum security when working on live-adjacent circuits, the entire panel door can be locked if your panel has a built-in lock point (many Square D and Siemens panels do).
Turn off the breaker for the circuit being worked on. Install a breaker lockout clip over that breaker. Attach a padlock through the lockout clip and keep the key with you while working. Place a written tag on the panel door (or tape a note over the breaker) identifying the work in progress and your contact number. Before starting work, verify the circuit is de-energized at the outlet or fixture with a non-contact voltage tester — never skip this step even with the breaker locked out, as mislabeled panels are common. When work is complete, remove the tester, then remove the lockout and restore the breaker in that order.
Work on the main panel interior (replacing breakers, installing new circuits) requires locking out the main breaker or, in many cases, contacting the utility to disconnect power at the meter — since the service entry wires above the main breaker remain live even with the main off. In Ontario, work inside the panel requiring exposure to the main lugs is ESA-licensed electrician territory. A licensed electrician carries their own LOTO equipment and handles the utility coordination when needed.
The most common mistake homeowners make is relying on tape or a sticky note on the breaker instead of a physical lockout device. Tape falls off and sticky notes get removed. A $5 breaker lockout clip and a padlock cost less than an emergency room visit and cannot be accidentally bypassed. Keep a pack of lockout clips with your electrical tools so they’re always available when you need them. We carry them on every service call and use them every time — no exceptions, regardless of how short the job is.
Need electrical panel work done safely by a licensed electrician? Call us at 416-838-9006 or visit our contact page — we follow full LOTO procedures on every job across the GTA.
Electrician Since 2008 Journeyman Electrician Designated Master Electrician at EZSMART Corp