loading
EZSMART Corporation, ESA/ECRA #7012690 , North York , Ontario
Mon-Fri 08:00 AM - 05:00 PM
EZSMART Corporation, ESA/ECRA #7012690 , North York , Ontario
Mon-Fri 08:00 AM - 05:00 PM
Shopping Cart
  • No products in the cart.
  • Shopping Cart
  • No products in the cart.
  • Post Image
    14 Jul, 2026
    Posted by EZSMART Corp
    0 comment

    Why Are My Light Bulbs Burning Out So Quickly?

    Changing a bulb every few weeks is not normal. A standard LED bulb should last 15,000 hours or more — roughly 10 to 15 years of ordinary use. If your light bulbs are burning out quickly in one fixture, one room, or across the whole house, the bulb is not the problem: something in the fixture, the wiring, or the incoming voltage is killing it early.

    Why your light bulbs are burning out so quickly: the top five causes

    The most common cause we see is high supply voltage. Toronto Hydro delivers a nominal 120V, but readings above 125V will noticeably shorten every incandescent and even some LED bulb lives. Second is vibration — a ceiling fan, garage door opener, or laundry-room fixture shakes the filament or driver until it fails. Third, a loose neutral or hot wire at the fixture creates arcing that spikes the bulb. Fourth, using the wrong bulb type in an enclosed fixture traps heat and cooks the driver. Fifth, cheap dimmers paired with non-dimmable LEDs will burn them out in weeks.

    Enclosed fixtures deserve special attention. A standard LED bulb needs airflow around its base to keep its internal driver cool; drop the same bulb into a fully sealed dome light or shower fixture and the driver can hit 100°C within an hour. Always look for “suitable for enclosed fixtures” on the box, or your one-year LED will fail in three months.

    How to diagnose it yourself in five minutes

    Try this order. Swap in a known-good, name-brand bulb of the correct wattage and base — if it lasts, the last bulb was defective. Check the fixture label for the maximum wattage; over-lamping is a common mistake. Look for scorch marks or discolouration in the socket. If bulbs are burning out in multiple rooms, borrow a $30 plug-in voltage meter and check your outlets: anything over 125V calls for a Toronto Hydro service check. If the socket looks charred or the fixture is warm, stop and call an electrician for a professional repair.

    When burning bulbs signal something more serious

    If bulbs are burning out throughout the entire house, along with any of these symptoms — lights suddenly getting brighter, other devices behaving strangely, buzzing at the panel — you may have an open or failing neutral on the service. That is the same fault that can push 240V through a 120V bulb and cook it in seconds. It is dangerous and needs a licensed electrician on-site immediately. Do not keep replacing bulbs; you are treating the symptom.

    Expert tip from our GTA installers

    Keep the receipt on any pot-light retrofit and any LED bulb that dies inside a year. Most name-brand LEDs are warrantied for 3 to 5 years, and the manufacturer will replace them free if you send in the failed unit. When we fix flickering or short-lived lights, we always ask the homeowner to save one dead bulb — the way the filament or driver failed tells us exactly what went wrong upstream.

    Contact us

    Tired of buying bulbs every month? Let us find and fix the real cause. Call 416-838-9006 or visit our contact page and we will diagnose it on the first visit.

    Recent Comments

    No comments to show.

    Archive

    July 2026
    M T W T F S S
     12345
    6789101112
    13141516171819
    20212223242526
    2728293031  

    Recent Posts

    16 Jul, 2026

    Do Bathrooms Require 20-Amp Circuits in Ontario? (OESC 2025 Answer)

    Bathroom outlets get abused daily — hairdryers, curling irons, space

    08 Jul, 2026

    Why Does My Breaker Keep Tripping?

    A breaker that trips once in a while is usually nothing to worry about

    Chat with us